Open Source RDBMS - Seamless, Scalable, Stable and Free

한국어 | Login |Register

Versions available for this page: CUBRID 8.3.0 |  CUBRID 8.3.1 |  CUBRID 8.4.0 | 

Managing Specific Broker

Enter the following to start broker1 only. Here, broker1 is a broker that has been already configured in the shared memory.

% cubrid broker on broker1

The following message appears if broker1 is not configured in the shared memory.

% cubrid broker on broker1

Cannot open shared memory

Enter the following to stop broker1 only. Here, you can also remove the service pool of broker1.

% cubrid broker off broker1

Enter the following to restart broker1.

% cubrid broker restart broker1

The broker reset feature disconnects the existing connection and reconnects again when CAS connects to an unwanted database with failover and etc. For example, once the Read Only broker connects to an active server, it does not reconnect to the standby server automatically even though the standby server is available to connect, and you can disconnect the existing connection and reconnect to the standby server again only through the "cubrid broker reset" command.

To reset broker1, input the following:

% cubrid broker reset broker1